How Do I Reset My Dodge Anti Theft System?
How do i reset my dodge anti theft system?. Many Dodge Chrysler vehicles are equipped with radios that require a special anti-theft radio code. When a PCM SBEC and the Sentry Key Immobilizer Module SKIMare replaced at the same time perform the following steps in order. The only bad thing is that my anti-theft is not working but that is fine with me right now.
Do this a total of three times in under 5 seconds. You will need to get it to the dealer to get the system reset. Meanwhile check out our expert review on the best exhaust system for dodge ram 1500 Hemi the best Tonneau cover for RAM 1500.
This code is not required unless the radio is removed from the vehicle or the vehicles battery is disconnected. This blog will shed light on how to disable alarm on Dodge Ram. Resetting the anti-theft system on this truck is pretty straight-forward.
I once had a similar problem when I installed my HIDs but I had a no Bus flashing on the dash. Program the new PCM SBEC. Try disconnecting the battery for 15mins just the negative terminal at the strut tower it requires a 15mm spanner or socket or you can even use an adjustable wrench.
Repeat the process at least a couple of times if it does not work the first time. How do you reset the anti-theft system on a Dodge Ram 2500. I tried to start the car and the battery was dead from too many alarms going off.
Then put the key back in and try to start the car. The security system on a Dodge Caravan acts as an anti-theft deterrent. The security system uses a proximity sensor and ignition kill switch to help prevent unauthorized vehicle use.
It also acts as the keyless entry receiver. Program the new SKIM.
Now insert the key into the ignition of the truck.
How do you reset the anti-theft system on a Dodge Ram 2500. Then unlock just the drivers side door and go ahead and place the key into the ignition and turn it to the ON position. Fixed it on my own kind of. Check the anti-theft light again. This code is not required unless the radio is removed from the vehicle or the vehicles battery is disconnected. If it is not lit up anymore turn the key back to off and leave it for a couple of minutes. Open the fuse box under the hood and find the IOD fuse. Now insert the key into the ignition of the truck. This blog will shed light on how to disable alarm on Dodge Ram.
Try disconnecting the battery for 15mins just the negative terminal at the strut tower it requires a 15mm spanner or socket or you can even use an adjustable wrench. This gives the system time to reset or you wont be able to start your car. Wait for a couple of minutes to make sure that the system reset is finished. If that doesnt work exit the vehicle and roll. If its no longer blinking turn the key back to the Off position and allow it to set for a minute or two. Jump started the car and all is fine. Hop in the vehicle.
Post a Comment for "How Do I Reset My Dodge Anti Theft System?"